LED dimmer mini with constant current - in the twinkling of an eye white LED spots can be dimmed

For easy control of LED spots, lamps and lights, you can do without typical light switches. Here, a highly sensitive IR sensor does the work and makes everyday household life much easier. The iluminize LED dimmer mini allows dimming and switching by hand sensor, which also brings certain advantages. For operation, your LEDs must meet the following requirements:

• dimmable via pulse width modulation (PWM)

• operation by constant current (350mA/700mA)

• they are single color LED spots (e.g. white)

Easy handling when switching

Just pass the sensor with your hand in a distance of up to 6cm to switch your light on and off. With each further reflection the light is switched on and off again.

Controlled dimming

Hold your hand in the detection area for a short while to dim the light up or down. It will be dimmed in a cyclic rhythm darker-brighter-darker-brighter.

The dimming time is about 16 -20 seconds in which you can adjust your desired brightness smoothly and continuously. Thanks to the 750Hz PWM radio frequency, you dim your LED spots cleanly and without flickering.

Precise thanks to IR sensor

The infrared sensor (IR) has a highly sensitive detection range of 1-6 cm. This detects every movement even in the dark, so precise use is possible even in closets.

Memory function

This available function allows the dimmer to save the last setting. The next time you turn it on, it will automatically recall the last brightness setting.

Powerful

The LED dimmer has an output of 350mA or 700mA and works with constant current. The maximum wattage of the connected LED spots, lamps and luminaires must not exceed the following values, depending on the input voltage:

IP20

The LED dimmer as well as hand sensor may only be used indoors. Both components must be protected from high humidity and dirt.

Installation & Mounting

Our iluminize LED dimmer mini with hand sensor comes in a small and compact format. So you are flexible in the installation and can simply let the dimmer disappear. For the power supply and the operation of your LED spots you need a 12V-36V power supply. The connection is made via only two cables.

The sensor can be installed in various surfaces with little effort. This requires a drill hole with ∅17mm to sink the IR sensor in the hole afterwards. With the enclosed nut (hexagonal) you fix the sensor at the desired location. Finally, the sensor and switch are connected with a connection cable (3-pin).

Scope of delivery

With the delivery you receive the following components:

• 1 x LED dimmer mini

• 1 x IR sensor with connection cable (100cm)

• 1 x instruction manual (ENG)